VID · Video tools

Fog Video Effect

Shareable link

Settings are written to the URL as you change them. Nothing differs from the defaults yet.

Fog on video has to move. A still fog pasted over moving footage reads as a dirty window within a second, because real fog drifts, thins and thickens while the scene goes on behind it. This effect runs the photo fog on every frame and adds a wind.

Placing the fog

Horizon is where the far distance sits, as a share of the height from the top. Aerial haze is thickest there and everything above it is treated as far. Ground fog pools below the line instead and thickens toward the bottom of the frame. An even veil ignores the horizon and fogs everything by the same amount. Reach sets how far forward the fog comes from the horizon, and Density how much of the scene is left at full depth.

Scene depth reads each frame the way a dehaze filter does, in reverse: a patch that is dark in all three channels is almost never far away, so it stays clearer. It is a guess, and a dark distant hill will stay clearer than it should.

Drift

Drift is a wind across the frame, left or right. The fog banks are two layers of noise. The wind carries the broad layer at the set speed and the fine layer at about one and a half times that, rising slightly, so the two slide against each other and the fog churns. At full drift the banks cross a fifth of the frame a second, which is a stiff breeze; a third of that reads as still air with slow movement in it.

The movement is measured as a share of the frame, so the preview at 720 pixels and the export at full size show the same bank in the same place at the same second.

Across frames

The pattern is seeded once for the clip. Nothing is re-rolled per frame, so there is no flicker and no state to drift, and the export pool can render frames in any order and still agree with the preview.

Where it stops

The horizon is a straight line fixed to the frame. A pan, a tilt or a handheld shot moves the real horizon under it, and the fog stays put. Lights do not glow through the fog: a lamp in the distance fades like everything else at that depth, where a real lamp would bloom. For that, run the glow effect after this one in the video workflow.

Frequently Asked Questions

It scatters light between the camera and the scene on every frame. Each pixel keeps a share of its own colour and takes the fog colour for the rest, falling off with a distance you place from the horizon and reach sliders, and the fog softens what it covers. Drift sets a wind, so the banks cross the frame and churn as the clip plays.

It moves. The banks are two layers of noise that the wind carries at different speeds, the finer one running ahead and rising, so they slide against each other and the fog churns instead of scrolling as one sheet. At zero drift it holds still, which suits a locked-off scene in calm air.

The horizon and the depth ramp are fixed to the frame, not to the scene. On a tripod shot that is correct. On a pan or tilt the horizon moves and the fog does not, so keep it to static shots or a drone hover.

No. The bank pattern is seeded once for the clip and only the wind moves it, so a frame at a given time always gets the same fog, in the preview and in the export.

It is copied into the export unchanged when the container can hold its codec, and re-encoded when it cannot. A note under the export button says which happened.

Explore Our Tools

Browse all tools