A window’s shadow is the cheapest way to put sunlight into a photo that was lit flat. Photographers cut a gobo and hold it in front of a lamp; here the gobo is one of four patterns projected across the picture.
Patterns
Venetian blinds are horizontal slats with the gaps between them. Window panes is a single window of six panes in a frame, with wall around it, so the shadow is the window’s and not a grid of them. Leaves scatters two layers of leaf shapes, each placed and turned by its own hash so no two runs look stamped. Dappled light is the sun through a canopy: mostly shade with small bright gaps.
Angle and perspective
Angle rotates the pattern about the centre of the frame. Perspective keystones it: the pattern spreads toward the bottom of the frame and compresses toward the top, which is what a shadow does when light falls across a surface at a slant. Low perspective reads as a wall facing the window square on; high perspective as light raking across a floor or a desk.
Scale sets one repeat of the pattern as a share of the short edge, so the export carries the same shadow as the preview whatever the resolution.
Softness
A shadow’s edge is sharp where the object casting it is close to the surface and soft where it is far. Softness is that penumbra for the whole frame: 0 is a blind touching the wall, 100 is a window across the room.
Shadow and sunlight
Shadow is the depth of the shaded parts in stops: full strength is three and a half stops below the sun, about what open shade measures on a clear day. The multiplication is done in linear light, so the shaded parts darken the way a real shadow does rather than going flat grey.
Sunlight splits the colour. Direct sun is warm and a shadow is filled only by the blue sky, so lit areas go warmer and brighter and shaded areas cooler. At 0 the shadow is neutral.
Example: a product on a white background
Choose Venetian blinds, Scale around 25, Angle around -20 and Perspective near 40 so the slats run diagonally and open up toward the bottom. Softness 30 keeps the slats readable without a hard edge. Shadow 70 and Sunlight 50 give warm stripes with cool shade between them. If the stripes cut across the product’s label, raise Scale until one stripe covers it.
Where it stops
The shadow is projected flat. Nothing in it bends around a face, a bottle or a fold of cloth, and nothing is masked out, so a subject and its background receive the same shadow. For a portrait, keep Softness high and Shadow moderate, or the flat stripes on the face give it away.