AUD · Audio tools

Lossy Codec Effect

Shareable link

Settings are written to the URL as you change them. Nothing differs from the defaults yet.

Oxyd To put the result on a track with other audio, Oxyd is a multitrack editor with the same effects. Open Oxyd

Starve a recording of bits. The damage is the kind a low-bitrate MP3, an old streaming link or a failing video call does: no top end, a swirl in what is left, a smear before each drum hit, and gaps where packets went missing.

What low bitrates take away

A transform codec turns each short frame of audio into a spectrum, groups the frequencies into bands, and gives each band a rounding step sized against that band’s level. Anything smaller than half a step becomes zero. With plenty of bits the steps are small and the rounding is inaudible. With too few, three things happen.

The top is cut. There are no bits for it. The cutoff here runs from 3.5 kHz at 8 kbps to 7.5 kHz at 32 kbps and 16 kHz at 128 kbps.

Bands thin out. Only the strongest frequencies in each band survive the rounding, and the set of survivors changes from frame to frame. That flicker is the watery, phasey sound usually described as underwater or metallic.

Transients smear. Rounding error spreads across the whole frame, about 46 ms, so part of a drum hit is heard before the hit itself. This is pre-echo.

Bitrate

Setting Sounds like
128 kbps Close to clean, with a slightly closed top
64 kbps Early streaming audio: dull, a little swirl on cymbals
32 kbps A voice call or a talk-radio stream
16 kbps Heavy swirl, music becomes texture
8 kbps A few surviving tones per band

The numbers are calibrated by ear against what those rates sound like, and they are a description of the damage, not a file size. Nothing here runs an encoder.

Dropouts

Dropouts lose a share of the stream in bursts of about 60 ms. Each gap is concealed the way decoders conceal one: the last good frame is held and faded. At 5% it is an occasional glitch. At 20% and above it is the robotic stutter of a call about to disconnect. The pattern is fixed for a given file, so an export matches its preview.

Mix

Lower Mix to keep the clean signal under the damaged one. On a vocal, 30 to 50 at a low bitrate adds the grain of an old download while the words stay clear.

Hearing only the damage

Export at Mix 100, then load the original and the export into the null test. What is left after subtraction is everything the model threw away, which is a quick way to learn what a low bitrate costs on a given recording.

The bitcrusher reduces word length and sample rate, which adds noise and aliasing and sounds like early samplers. The lo-fi effect combines that with tape and vinyl. Neither produces the swirl, which belongs to codecs that work on a spectrum.

Frequently Asked Questions

It makes an audio file sound as if it had been encoded at a very low bitrate. The top of the spectrum is cut off, the quieter frequencies inside each band are rounded away from frame to frame, which produces the watery swirl of a poor MP3, and optional dropouts imitate lost packets. It reads WAV, MP3, M4A, AAC, Ogg, Opus, FLAC, AIFF and WebM audio.

No. It models the quantiser of a transform codec: a short-time spectrum, grouped into bands, with a rounding step per band that grows as the bitrate falls. There is no psychoacoustic model and no entropy coding, so the Bitrate control describes how damaged the result sounds, not the size of a file. The export is whatever format you choose, at full quality.

Use the audio compressor, which runs a real encoder to a target size or bitrate. This page is for the sound of heavy compression as an effect, with a mix control, inside a file that stays clean.

At a low bitrate each band of the spectrum can keep only its strongest frequencies, and which ones survive changes every frame. Tones flicker in and out thousands of times a minute. Engineers call them birdies, and they are most obvious on cymbals, reverb and applause.

They remove bursts of about 60 ms, up to 30% of the stream, and fill each gap the way a decoder hides a lost packet: by repeating the last good frame as it fades. The result is the buzzing stutter of a call on a weak connection.

Explore Our Tools

Browse all tools