Compress each band from both sides. Three bands, each with an upper threshold it is pushed down to and a lower threshold it is lifted up to, which is the sound electronic producers ask for by the name of the preset that started it: OTT, over the top.
Two thresholds per band
Every band has a dead zone a few decibels wide. Audio inside it is left alone. Audio above it is compressed downward at 20:1, close to limiting. Audio below it is compressed upward at about 4.2:1, with at most 24 dB of lift.
| Band | Lift below | Squeeze above | Attack | Release |
|---|---|---|---|---|
| Low | -40.8 dBFS |
-33.8 dBFS |
47.8 ms |
282 ms |
| Mid | -41.8 dBFS |
-30.2 dBFS |
22.4 ms |
282 ms |
| High | -40.8 dBFS |
-35.5 dBFS |
13.5 ms |
132 ms |
The result is a band whose level barely moves. Reverb tails, room sound, fret noise and the fizz in a sawtooth all arrive nearly as loud as the notes they hung behind.
Depth
Depth scales the gain the detectors ask for. At 100 the full curve is applied and a mix turns dense and bright to the point of harshness. Between 20 and 40 it works as a finishing move on a synth bus or a drum loop. The downward half would make the file quieter as Depth rises, so 12 dB of make-up gain rises with it.
Upward and Downward
The two halves have their own amounts. Downward at 0 leaves a pure upward compressor: peaks untouched, quiet detail raised. Upward at 0 leaves a three-band downward compressor with a steep ratio. The classic sound is both at 100 with Depth doing the blending.
Time
Time scales every band’s attack and release together, from 25% to 400%. Short times follow each cycle of a bass note and add grain. Long times ride the level like a slow fader and keep more of the original punch, because a transient gets through before its band is turned down.
Crossovers
The splits default to 88 Hz and 2.5 kHz and move from 40 Hz to 300 Hz and from 1 kHz to 8 kHz. Raise the low split to keep a whole bass line in the slow band. The filters are fourth-order Linkwitz-Riley, 24 dB per octave, so a kick drum does not leak into the mid band and get compressed twice.
Band gains and output
Each band has a gain from -12 dB to +6 dB after its compressor. OTT brightens almost anything, since the top band holds the most quiet detail to lift, and turning High gain down a few decibels is the usual correction. Output trims the sum.
After it
Peaks slip through during each band’s attack, more so at long Time settings. Put the limiter after this stage when the result is going to a file that must not clip.