AUD · Audio tools

Mix Checker

Shareable link

Settings are written to the URL as you change them. Nothing differs from the defaults yet.

Oxyd To put the result on a track with other audio, Oxyd is a multitrack editor with the same effects. Open Oxyd

Play a mix through eight playback systems without leaving the desk. Each device takes away what it cannot reproduce and adds what its box and driver add, so the problems that would show up on the bus home show up now.

Devices

Device Bass stops near Top stops near Stereo Limiter
Phone speaker 480 Hz 12 kHz Mono Yes
Laptop speakers 220 Hz 14 kHz Narrow Yes
Cheap earbuds 60 Hz Full Full No
TV speakers 140 Hz 11 kHz Slightly narrow Yes
Small Bluetooth speaker 90 Hz 13 kHz Mono Yes
Mono mid-range cube 110 Hz 10 kHz Mono No
Car 35 Hz Full, tilted down Narrow No
Club system 32 Hz Full, tilted down Bass-heavy, narrow Yes

Between those limits each profile has the bumps of its class: the phone’s peak near 2.8 kHz, the boxy 250 Hz of a flat TV, the 120 Hz thump a Bluetooth speaker’s passive radiator makes in place of real bass, the cabin boom and scooped low mids of a car.

What each one reveals

Phone and Bluetooth speaker. Bass that exists only below 100 Hz vanishes. Stereo effects vanish with it: both are one driver, so anything panned hard or out of phase between the channels is summed, and wide synths can drop in level or cancel.

Mono cube. The classic studio check. With no bass and no top, only the mid-range is left, and that is where the vocal, snare and guitars have to be balanced. A mix that holds together here holds together on most things.

Earbuds. A bass bump, a dip in the presence range and a peak around 8.5 kHz. Harsh sibilance and hi-hats get harsher.

Car. Boomy lows and recessed low mids. A mix with too much 80 Hz to 100 Hz turns to mud.

Club. Heavy sub, a system limiter, and a narrow image. Kick and bass that fight each other pump against the limiter.

Playback volume

The devices with a limiter are quiet until pushed. Playback volume drives the mix 12 dB harder or softer into that limiter and returns the output to the level it came in at, so the control changes how flattened the peaks are and not how loud the preview is. Check a dense master at 75 or higher: that is where a phone starts to pump.

Amount

100 is the device. 0 is the untouched file. The preview’s own bypass switch does the same comparison in one click, and level matching keeps the quieter device from sounding worse only because it is quieter.

Limits

The profiles are archetypes, not measurements of products. Headphones cannot reproduce the room a speaker plays into, or the way a car’s bass is felt as much as heard. Use the checker to find problems early, then confirm on a real device.

Fixing what it finds

Missing bass on small speakers is the most common finding. The virtual bass tool generates harmonics of the sub band in a range a small driver can play, and an exciter or light saturation on the bass track does the same by hand. For a mix that collapses in mono, the stereo analyzer shows the correlation that predicts it.

Frequently Asked Questions

It plays an audio file through a model of a playback device: a phone speaker, laptop speakers, cheap earbuds, a TV, a small Bluetooth speaker, a mono mid-range cube, a car or a club system. Each one cuts the bass and treble where that kind of device does, adds its resonances, narrows or sums the stereo image, and limits loud passages if the device would. It reads WAV, MP3, M4A, AAC, Ogg, Opus, FLAC, AIFF and WebM audio.

No. Each profile is an archetype built from how that class of device behaves, such as a phone driver that rolls off under about 480 Hz and peaks near 2.8 kHz. It does not reproduce a specific model, and two real phones differ from each other by more than either differs from the profile.

Whether the bass line and kick can still be followed. A phone plays nothing under a few hundred hertz, so a bass part made only of sub frequencies disappears. If it does, add harmonics above 200 Hz with saturation or the virtual bass tool and check again.

How hard the device is driven into its own limiter. Phones, laptops, TVs and small Bluetooth speakers turn loud passages down to protect the driver. At a higher volume more of the mix is over that limit, so peaks flatten and the mix pumps. The output level is held steady so only the squashing changes.

Yes. The export is the file as that device would play it, which is also a phone-speaker or car-stereo effect for video and sound design.

Explore Our Tools

Browse all tools